Easy to fix: just mount the feeder higher. Most of the plugs I see out there would work, but you'd be back to the height problem (if you're concerned about chicken ergonomics). Of course, it's best to use plastic or something else that can be thoroughly cleaned. It will take you more than 3 minutes to assemble, but it would be more efficient. Another way to go (and in response to some reader comments): if you add some kind of plug right at the bottom of the Y, the birds would be able to reach all the food. This will make it harder for chickens to access the feed. Snow will also fall on the feed in open feeders. The purpose of chicken feeders is to provide feed for chickens throughout the day. Water placed outside will most likely freeze, making it inaccessible to your chickens. Get premium chicken feeders with Little Peckers. At first the bottom part connected to the "Y" was only three inches long and the birds didn't like that much, so we set it up on a brick and the chickens seemed to like the altitude better, so the final version uses a six-inch length of pipe to place the food where the chickens can easily reach it. It is intuitive to place the feeder and waterer where the chickens are. We considered quite a few other variations, but they all had drawbacks mostly related to spillage and security. But I haven't seen the extra three-inch piece added to the Y connector: without that small extension the chickens managed to spill quite a lot of food, but that three-inch piece cut spillage to almost zero! We tried a 180-degree elbow with the edge cut off: the birds were able to eat just fine but they spilled quite a lot, and closing the pipe for waterproofing and rodent-proofing would have required additional engineering. There are lots of PVC chicken feeders out there, and several folks have gone with a design very similar to this one.
0 kommentar(er)
